Posts / Foundation

[Foundation] Applied Electronics

Applied Electronics

[Foundation] Applied Electronics

1. Resistor

1.1 Voltage Division

Resistors can be connected in series to divide voltage, commonly used for ADC inputs or op-amp biasing.

  • Consider the resistance ratio and ADC resolution when designing a divider.
  • If low quiescent current is required, the divider’s output impedance increases, which affects accuracy:
    • The ADC’s internal sampling capacitor may not fully charge.
    • The measured voltage may have error due to the RC time constant.
  • When measuring high currents, use a high-power resistor to handle heat dissipation.

1.2 Current Limiting

Used to limit current to safe levels.

  • Typical use cases: LED current control, MOSFET gate protection, transistor base drive.

1.3 Pull-Up / Pull-Down

Used to define a stable logic level on floating pins (e.g., MCU inputs, I²C lines).

  • Provides source current for open-drain/open-collector circuits.
  • Typical resistance ranges:
    • I²C: 2.2k–400kΩ (commonly 4.7k–10kΩ)
    • MCU GPIO: ~10kΩ
  • When low-power operation is critical, choose higher resistance to reduce quiescent current.

1.4 Stabilization / Damping

Used to isolate and stabilize signal lines.

  • Known as isolation resistors or damping resistors.
  • Reduces ringing, EMI, and cross-coupling on high-speed or sensitive traces.

2. Capacitor

2.1 Filtering / Decoupling

Used to smooth voltage and suppress high-frequency noise.

  • Place as close as possible to IC power pins.
  • Typical range: 0.01 µF – 100 µF.
  • Pay attention to ESR (Equivalent Series Resistance) and stability.

2.2 Timing / Oscillator

Used in RC or LC timing and oscillator circuits.

  • Time constant: τ = R × C
  • Consider tolerance, temperature drift, and leakage current when selecting values.

2.3 Coupling / AC Blocking

Used to pass AC signals while blocking DC bias.

  • Common in audio and amplifier stages.
  • Choose capacitors with appropriate voltage ratings and low distortion.

2.4 Bypass / Noise Reduction

Used to shunt high-frequency noise and improve signal integrity.

  • Small ceramic capacitors (e.g., 0.01 µF, 0.1 µF) are placed close to active components.
  • Use multiple capacitors in parallel (e.g., 0.1 µF + 10 µF) to cover a wide frequency range.

2.5 Energy Storage / Pulsing

Used to store and release energy for short bursts.

  • Common in power supplies and motor drivers.
  • Use large electrolytics or supercapacitors with sufficient voltage and ripple current ratings.

2.6 Snubber / Damping

Used to suppress voltage spikes, ringing, and protect switches.

  • Typically RC series networks.
  • Values depend on transient energy, switching frequency, and load characteristics.